Hzqjchain Motorcycle Chain Manufacturer Introduces Details Of I

  • In life, you often see where chains are used. So what are the correct steps when using these chains? Today, Hzqjchain Motorcycle Chain manufacturers will share general chain installation steps.

    1. The sprocket should be installed on the shaft and must not be skewed or swayed. The end faces of two sprockets in the same gearbox assembly should be on the same plane. When the center distance of the sprocket is between 0 and 5 meters, the allowable deviation is 1 mm; when the center distance of the sprocket is greater than 0 and 5 meters, the allowable deviation is 2 Mm. However, no friction is allowed on the sprocket teeth. If the two wheels deviate too much, it is easy to cause off-chain and accelerated wear. When replacing the sprocket, care must be taken to check and adjust the offset.

    2. The tightness of the chain should be appropriate. Too tight will increase power consumption and the bearings are prone to wear. The chain is too loose to jump off the chain easily. The tightness of the chain is: lifted or depressed from the middle of the chain, the center distance between the two sprockets is about 2-3cm.

    3. The new chain is too long or stretched after use, and it is difficult to adjust. Depending on the situation, the link is deleted, but it must be even. The chain link should pass through the back of the chain, the locking element is inserted outside, and the opening of the locking element should face the opposite direction of rotation.

    4. When the sprocket is severely worn, it should be replaced with a new sprocket and a new chain at the same time to ensure good meshing. You cannot replace a new chain or sprocket separately. Failure to do so will result in poor meshing and will accelerate wear on the new chain or sprocket. After the tooth surface of the sprocket is worn to a certain extent, it should be turned in time. Extended use time.

    5. The old chain cannot be mixed with a part of the new chain, otherwise it is easy to generate impact in the transmission and break the chain.

    6. During the work, the chain should be filled with lubricating oil in time. Lubricating oil must enter the mating clearance of the roller and inner sleeve to improve working conditions and reduce wear.

    7. After the machine is stored for a long time, the chain should be removed and cleaned with kerosene or diesel, then coated with oil or butter, and then stored in a dry place to prevent corrosion.

    information about Motorcycle Chain : https://www.hzqjchain.com/